From: Khoa Hoang Date: Fri, 8 Nov 2024 05:51:36 +0000 (-0800) Subject: eth: asix88179: packet drop when receiving large fragmented packets X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=05278af8b3df1c0c02e345ccf4c8c59bd0111f68;p=u-boot.git eth: asix88179: packet drop when receiving large fragmented packets The ASIX 88179A drops packets when receiving fragmented packets larger than the MTU size due to an insufficient URB buffer size. This change synchronizes the URB buffer size with the configuration used in the Linux kernel, resolving the packet drop issue. To reproduce the issue, set the following configuration: CONFIG_IP_DEFRAG=y CONFIG_TFTP_BLOCKSIZE=16352 Then, run the `tftp` command. It will fail with a timeout error: U-Boot> tftp zero.bin Using ax88179_eth device TFTP from server 10.0.0.196; our IP address is 10.0.0.18 Filename 'zero.bin' Load address: 0x10000000 Loading: T T T T T T T T T T T Retry count exceeded; starting again Signed-off-by: Khoa Hoang Reviewed-by: Marek Vasut --- diff --git a/drivers/usb/eth/asix88179.c b/drivers/usb/eth/asix88179.c index 4bd353b93a..69d3073b66 100644 --- a/drivers/usb/eth/asix88179.c +++ b/drivers/usb/eth/asix88179.c @@ -173,7 +173,7 @@ #define USB_BULK_SEND_TIMEOUT 5000 #define USB_BULK_RECV_TIMEOUT 5000 -#define AX_RX_URB_SIZE 1024 * 0x12 +#define AX_RX_URB_SIZE 1024 * 0x1a #define BLK_FRAME_SIZE 0x200 #define PHY_CONNECT_TIMEOUT 5000 #define PHY_RESET_TIMEOUT 500 @@ -193,10 +193,10 @@ static const struct { unsigned char ctrl, timer_l, timer_h, size, ifg; } AX88179_BULKIN_SIZE[] = { - {7, 0x4f, 0, 0x02, 0xff}, - {7, 0x20, 3, 0x03, 0xff}, - {7, 0xae, 7, 0x04, 0xff}, - {7, 0xcc, 0x4c, 0x04, 8}, + {7, 0x4f, 0, 0x12, 0xff}, + {7, 0x20, 3, 0x16, 0xff}, + {7, 0xae, 7, 0x18, 0xff}, + {7, 0xcc, 0x4c, 0x18, 8}, }; /* driver private */ @@ -332,7 +332,7 @@ static int asix_basic_reset(struct ueth_data *dev, memcpy(tmp, &AX88179_BULKIN_SIZE[0], 5); asix_write_cmd(dev, AX_ACCESS_MAC, AX_RX_BULKIN_QCTRL, 5, 5, tmp); - dev_priv->rx_urb_size = 128 * 20; + dev_priv->rx_urb_size = 1024 * 20; /* Water Level configuration */ *tmp = 0x34;