From: Heiko Schocher <hs@denx.de>
Date: Thu, 28 May 2015 05:27:36 +0000 (+0200)
Subject: am33xx, spl, siemens: enable debug uart output again
X-Git-Url: http://git.dujemihanovic.xyz/?a=commitdiff_plain;h=012681b1fa822492bb8fdc5c2dd3d24d6092e110;p=u-boot.git

am33xx, spl, siemens: enable debug uart output again

a6b541b090: TI ARMv7: Don't use GD before crt0.S has set it

moves the init of the debug uart at the very end of SPL code.
Enable it for the siemens board earlier, as they print
ddr settings ... all debug output before board_init_r()
is here currently useless. Maybe we must rework this
globally?

Signed-off-by: Heiko Schocher <hs@denx.de>
---

diff --git a/board/siemens/common/board.c b/board/siemens/common/board.c
index cc0ac6b0bd..fb2de48fbc 100644
--- a/board/siemens/common/board.c
+++ b/board/siemens/common/board.c
@@ -43,6 +43,11 @@ void set_mux_conf_regs(void)
 	/* Initalize the board header */
 	enable_i2c0_pin_mux();
 	i2c_set_bus_num(0);
+
+	/* enable early the console */
+	gd->baudrate = CONFIG_BAUDRATE;
+	serial_init();
+	gd->have_console = 1;
 	if (read_eeprom() < 0)
 		puts("Could not get board ID.\n");