mpc5200: digsy_mtc: fix extension board EEPROM I2C address for rev5

On newer rev5 hardware the extension board EEPROM I2C address
has been changed to 0x54. Make this I2C address configurable
depending on CONFIG_DIGSY_REV5 so that extention board presence
detection works correctly on newer hardware.

Signed-off-by: Anatolij Gustschin <agust@denx.de>

diff --git a/board/intercontrol/digsy_mtc/digsy_mtc.c b/board/intercontrol/digsy_mtc/digsy_mtc.c
index 784ba2ac046f49783ac124420ab8c3df8b0c3eae..4d6b33d9aa74890c3ee32db32eec51f53ed15532 100644 (file)
--- a/board/intercontrol/digsy_mtc/digsy_mtc.c
+++ b/board/intercontrol/digsy_mtc/digsy_mtc.c
@@ -220,9 +220,6 @@ int checkboard(void)
 
 #define GPT_GPIO_ON            0x00000034      /* GPT as simple GPIO, high */
 
-/* ExBo I2C Addresses */
-#define EXBO_EE_I2C_ADDRESS    0x56
-
 static void exbo_hw_init(void)
 {
        struct mpc5xxx_gpt *gpt = (struct mpc5xxx_gpt *)MPC5XXX_GPT;
@@ -232,7 +229,7 @@ static void exbo_hw_init(void)
        unsigned char val;
 
        /* 1st, check if extension board is present */
-       if (i2c_read(EXBO_EE_I2C_ADDRESS, 0, 1, &val, 1))
+       if (i2c_read(CONFIG_SYS_EXBO_EE_I2C_ADDRESS, 0, 1, &val, 1))
                return;
 
        /* configure IrDA pins (PSC6 port) as gpios */

diff --git a/include/configs/digsy_mtc.h b/include/configs/digsy_mtc.h
index ec5223cd1f94491b07f0f26c2c898d114b7e59e4..522ec57b13f95f3d3e55ed9291262ba6c3e41997 100644 (file)
--- a/include/configs/digsy_mtc.h
+++ b/include/configs/digsy_mtc.h
@@ -288,6 +288,13 @@
 #define CONFIG_SYS_DS1339_TCR_VAL      0xAB    /* diode + 4k resistor */
 #endif
 
+/* ExBo I2C Addresses */
+#if defined(CONFIG_DIGSY_REV5)
+#define CONFIG_SYS_EXBO_EE_I2C_ADDRESS 0x54
+#else
+#define CONFIG_SYS_EXBO_EE_I2C_ADDRESS 0x56
+#endif
+
 /*
  * Flash configuration
  */