dtb-$(CONFIG_ROCKCHIP_RK3588) += \
rk3588-edgeble-neu6a-io.dtb \
+ rk3588-evb1-v10.dtb \
rk3588-rock-5b.dtb
dtb-$(CONFIG_ROCKCHIP_RV1108) += \
--- /dev/null
+// SPDX-License-Identifier: (GPL-2.0+ OR MIT)
+/*
+ * Copyright (c) 2023 Rockchip Electronics Co., Ltd.
+ */
+
+#include "rk3588-u-boot.dtsi"
+
+/ {
+ aliases {
+ mmc0 = &sdmmc;
+ mmc1 = &sdhci;
+ };
+
+ chosen {
+ u-boot,spl-boot-order = &sdhci;
+ };
+};
+
+&sdhci {
+ bootph-all;
+};
--- /dev/null
+// SPDX-License-Identifier: (GPL-2.0+ OR MIT)
+/*
+ * Copyright (c) 2021 Rockchip Electronics Co., Ltd.
+ *
+ */
+
+/dts-v1/;
+
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/pinctrl/rockchip.h>
+#include "rk3588.dtsi"
+
+/ {
+ model = "Rockchip RK3588 EVB1 V10 Board";
+ compatible = "rockchip,rk3588-evb1-v10", "rockchip,rk3588";
+
+ aliases {
+ mmc0 = &sdhci;
+ serial2 = &uart2;
+ };
+
+ chosen {
+ stdout-path = "serial2:1500000n8";
+ };
+
+ backlight: backlight {
+ compatible = "pwm-backlight";
+ power-supply = <&vcc12v_dcin>;
+ pwms = <&pwm2 0 25000 0>;
+ };
+
+ vcc12v_dcin: vcc12v-dcin-regulator {
+ compatible = "regulator-fixed";
+ regulator-name = "vcc12v_dcin";
+ regulator-always-on;
+ regulator-boot-on;
+ regulator-min-microvolt = <12000000>;
+ regulator-max-microvolt = <12000000>;
+ };
+
+ vcc5v0_sys: vcc5v0-sys-regulator {
+ compatible = "regulator-fixed";
+ regulator-name = "vcc5v0_sys";
+ regulator-always-on;
+ regulator-boot-on;
+ regulator-min-microvolt = <5000000>;
+ regulator-max-microvolt = <5000000>;
+ vin-supply = <&vcc12v_dcin>;
+ };
+};
+
+&gmac0 {
+ clock_in_out = "output";
+ phy-handle = <&rgmii_phy>;
+ phy-mode = "rgmii-rxid";
+ pinctrl-0 = <&gmac0_miim
+ &gmac0_tx_bus2
+ &gmac0_rx_bus2
+ &gmac0_rgmii_clk
+ &gmac0_rgmii_bus>;
+ pinctrl-names = "default";
+ rx_delay = <0x00>;
+ tx_delay = <0x43>;
+ status = "okay";
+};
+
+&i2c2 {
+ status = "okay";
+
+ hym8563: rtc@51 {
+ compatible = "haoyu,hym8563";
+ reg = <0x51>;
+ #clock-cells = <0>;
+ clock-output-names = "hym8563";
+ pinctrl-names = "default";
+ pinctrl-0 = <&hym8563_int>;
+ interrupt-parent = <&gpio0>;
+ interrupts = <RK_PD4 IRQ_TYPE_LEVEL_LOW>;
+ wakeup-source;
+ };
+};
+
+&mdio0 {
+ rgmii_phy: ethernet-phy@1 {
+ /* RTL8211F */
+ compatible = "ethernet-phy-id001c.c916";
+ reg = <0x1>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&rtl8211f_rst>;
+ reset-assert-us = <20000>;
+ reset-deassert-us = <100000>;
+ reset-gpios = <&gpio4 RK_PB3 GPIO_ACTIVE_LOW>;
+ };
+};
+
+&pinctrl {
+ rtl8211f {
+ rtl8211f_rst: rtl8211f-rst {
+ rockchip,pins = <4 RK_PB3 RK_FUNC_GPIO &pcfg_pull_none>;
+ };
+
+ };
+
+ hym8563 {
+ hym8563_int: hym8563-int {
+ rockchip,pins = <0 RK_PD4 RK_FUNC_GPIO &pcfg_pull_up>;
+ };
+ };
+};
+
+&pwm2 {
+ status = "okay";
+};
+
+&sdhci {
+ bus-width = <8>;
+ no-sdio;
+ no-sd;
+ non-removable;
+ max-frequency = <200000000>;
+ mmc-hs400-1_8v;
+ mmc-hs400-enhanced-strobe;
+ status = "okay";
+};
+
+&uart2 {
+ pinctrl-0 = <&uart2m0_xfer>;
+ status = "okay";
+};
if ROCKCHIP_RK3588
+config TARGET_EVB_RK3588
+ bool "Rockchip EVB1 v10"
+ select BOARD_LATE_INIT
+ help
+ RK3588 EVB is a evaluation board for Rockchp RK3588.
+
config TARGET_RK3588_NEU6
bool "Edgeble Neural Compute Module 6(Neu6) SoM"
select BOARD_LATE_INIT
default 0x80000
source board/edgeble/neural-compute-module-6/Kconfig
+source board/rockchip/evb_rk3588/Kconfig
source board/radxa/rock5b-rk3588/Kconfig
endif
--- /dev/null
+if TARGET_EVB_RK3588
+
+config SYS_BOARD
+ default "evb_rk3588"
+
+config SYS_VENDOR
+ default "rockchip"
+
+config SYS_CONFIG_NAME
+ default "evb_rk3588"
+
+config BOARD_SPECIFIC_OPTIONS # dummy
+ def_bool y
+
+endif
--- /dev/null
+EVB-RK3588
+M: Kever Yang <kever.yang@rock-chips.com>
+S: Maintained
+F: board/rockchip/evb_rk3588
+F: include/configs/evb_rk3588.h
+F: configs/evb-rk3588_defconfig
+F: arch/arm/dts/rk3588-evb-u-boot.dtsi
--- /dev/null
+# SPDX-License-Identifier: GPL-2.0+
+#
+# Copyright (c) 2023 Rockchip Electronics Co,. Ltd.
+#
+
+obj-y += evb-rk3588.o
--- /dev/null
+// SPDX-License-Identifier: GPL-2.0+
+/*
+ * Copyright (c) 2023 Rockchip Electronics Co,. Ltd.
+ */
+
+#include <fdtdec.h>
+#include <fdt_support.h>
+
+#ifdef CONFIG_OF_BOARD_SETUP
+static int rk3588_add_reserved_memory_fdt_nodes(void *new_blob)
+{
+ struct fdt_memory gap1 = {
+ .start = 0x3fc000000,
+ .end = 0x3fc4fffff,
+ };
+ struct fdt_memory gap2 = {
+ .start = 0x3fff00000,
+ .end = 0x3ffffffff,
+ };
+ unsigned long flags = FDTDEC_RESERVED_MEMORY_NO_MAP;
+ unsigned int ret;
+
+ /*
+ * Inject the reserved-memory nodes into the DTS
+ */
+ ret = fdtdec_add_reserved_memory(new_blob, "gap1", &gap1, NULL, 0,
+ NULL, flags);
+ if (ret)
+ return ret;
+
+ return fdtdec_add_reserved_memory(new_blob, "gap2", &gap2, NULL, 0,
+ NULL, flags);
+}
+
+int ft_board_setup(void *blob, struct bd_info *bd)
+{
+ return rk3588_add_reserved_memory_fdt_nodes(blob);
+}
+#endif
--- /dev/null
+CONFIG_ARM=y
+CONFIG_SKIP_LOWLEVEL_INIT=y
+CONFIG_COUNTER_FREQUENCY=24000000
+CONFIG_ARCH_ROCKCHIP=y
+CONFIG_TEXT_BASE=0x00a00000
+CONFIG_SPL_LIBCOMMON_SUPPORT=y
+CONFIG_SPL_LIBGENERIC_SUPPORT=y
+CONFIG_NR_DRAM_BANKS=2
+CONFIG_HAS_CUSTOM_SYS_INIT_SP_ADDR=y
+CONFIG_CUSTOM_SYS_INIT_SP_ADDR=0xc00000
+CONFIG_DEFAULT_DEVICE_TREE="rk3588-evb1-v10"
+CONFIG_DM_RESET=y
+CONFIG_ROCKCHIP_RK3588=y
+CONFIG_SPL_ROCKCHIP_COMMON_BOARD=y
+CONFIG_SPL_MMC=y
+CONFIG_SPL_SERIAL=y
+CONFIG_SPL_STACK_R_ADDR=0x600000
+CONFIG_TARGET_EVB_RK3588=y
+CONFIG_SPL_STACK=0x400000
+CONFIG_DEBUG_UART_BASE=0xFEB50000
+CONFIG_DEBUG_UART_CLOCK=24000000
+CONFIG_SYS_LOAD_ADDR=0xc00800
+CONFIG_DEBUG_UART=y
+CONFIG_FIT=y
+CONFIG_FIT_VERBOSE=y
+CONFIG_SPL_LOAD_FIT=y
+CONFIG_OF_BOARD_SETUP=y
+CONFIG_DEFAULT_FDT_FILE="rockchip/rk3588-evb1-v10.dtb"
+# CONFIG_DISPLAY_CPUINFO is not set
+CONFIG_DISPLAY_BOARDINFO_LATE=y
+CONFIG_SPL_MAX_SIZE=0x20000
+CONFIG_SPL_PAD_TO=0x7f8000
+CONFIG_SPL_HAS_BSS_LINKER_SECTION=y
+CONFIG_SPL_BSS_START_ADDR=0x4000000
+CONFIG_SPL_BSS_MAX_SIZE=0x4000
+# CONFIG_SPL_RAW_IMAGE_SUPPORT is not set
+# CONFIG_SPL_SHARES_INIT_SP_ADDR is not set
+CONFIG_SPL_STACK_R=y
+CONFIG_SPL_ATF=y
+CONFIG_CMD_GPT=y
+CONFIG_CMD_MMC=y
+# CONFIG_CMD_SETEXPR is not set
+# CONFIG_SPL_DOS_PARTITION is not set
+CONFIG_SPL_OF_CONTROL=y
+CONFIG_OF_LIVE=y
+CONFIG_OF_SPL_REMOVE_PROPS="pinctrl-0 pinctrl-names clock-names interrupt-parent assigned-clocks assigned-clock-rates assigned-clock-parents"
+CONFIG_NET_RANDOM_ETHADDR=y
+CONFIG_SPL_REGMAP=y
+CONFIG_SPL_SYSCON=y
+CONFIG_SPL_CLK=y
+CONFIG_ROCKCHIP_GPIO=y
+CONFIG_SYS_I2C_ROCKCHIP=y
+CONFIG_MISC=y
+CONFIG_SUPPORT_EMMC_RPMB=y
+CONFIG_MMC_DW=y
+CONFIG_MMC_DW_ROCKCHIP=y
+CONFIG_MMC_SDHCI=y
+CONFIG_MMC_SDHCI_SDMA=y
+CONFIG_MMC_SDHCI_ROCKCHIP=y
+CONFIG_ETH_DESIGNWARE=y
+CONFIG_GMAC_ROCKCHIP=y
+CONFIG_REGULATOR_PWM=y
+CONFIG_PWM_ROCKCHIP=y
+CONFIG_SPL_RAM=y
+CONFIG_BAUDRATE=1500000
+CONFIG_DEBUG_UART_SHIFT=2
+CONFIG_DEBUG_UART_ANNOUNCE=y
+CONFIG_SYSRESET=y
+CONFIG_ERRNO_STR=y
- Rockchip Evb-RK3568 (evb-rk3568)
* rk3588
+ - Rockchip EVB (evb-rk3588)
- Edgeble Neural Compute Module 6 SoM - Neu6a (neu6a-io-rk3588)
- Radxa ROCK 5B (rock5b-rk3588)
make evb-rk3568_defconfig
make CROSS_COMPILE=aarch64-linux-gnu-
+To build rk3588 boards:
+
+.. code-block:: bash
+
+ export BL31=../rkbin/bin/rk35/rk3588_bl31_v1.33.elf
+ export ROCKCHIP_TPL=../rkbin/bin/rk35/rk3588_ddr_lp4_2112MHz_lp5_2736MHz_v1.09.bin
+ make evb-rk3588_defconfig
+ make CROSS_COMPILE=aarch64-linux-gnu-
+
Flashing
--------
--- /dev/null
+/* SPDX-License-Identifier: GPL-2.0+ */
+/*
+ * Copyright (c) 2023 Rockchip Electronics Co., Ltd.
+ */
+
+#ifndef __EVB_RK3588_H
+#define __EVB_RK3588_H
+
+#include <configs/rk3588_common.h>
+
+#define ROCKCHIP_DEVICE_SETTINGS \
+ "stdout=serial,vidconsole\0" \
+ "stderr=serial,vidconsole\0"
+
+#endif
projects / u-boot.git / commitdiff