]> git.dujemihanovic.xyz Git - u-boot.git/commitdiff
net: phy: aquantia: Enable autoneg when on USXGMII
authorValentin-catalin Neacsu <valentin-catalin.neacsu@nxp.com>
Tue, 30 Oct 2018 09:54:46 +0000 (09:54 +0000)
committerJoe Hershberger <joe.hershberger@ni.com>
Thu, 24 Jan 2019 17:35:30 +0000 (11:35 -0600)
If System Interface protocol is USXGMII then enable USXGMII autoneg

Signed-off-by: Valentin Catalin Neacsu <valentin-catalin.neacsu@nxp.com>
Acked-by: Joe Hershberger <joe.hershberger@ni.com>
drivers/net/phy/aquantia.c

index a0abb23299236ef1d29dbdc2a977ca46fc0d1521..3edc35eb210f4c24e03425a9a764904858fa1ee3 100644 (file)
@@ -3,6 +3,7 @@
  * Aquantia PHY drivers
  *
  * Copyright 2014 Freescale Semiconductor, Inc.
+ * Copyright 2018 NXP
  */
 #include <config.h>
 #include <common.h>
 #define AQUNTIA_SPEED_LSB_MASK 0x2000
 #define AQUNTIA_SPEED_MSB_MASK 0x40
 
+#define AQUANTIA_SYSTEM_INTERFACE_SR     0xe812
+#define AQUANTIA_VENDOR_PROVISIONING_REG 0xC441
+
+#define AQUANTIA_USX_AUTONEG_CONTROL_ENA 0x0008
+#define AQUANTIA_SI_IN_USE_MASK          0x0078
+#define AQUANTIA_SI_USXGMII              0x0018
+
 /* registers in MDIO_MMD_VEND1 region */
 #define GLOBAL_FIRMWARE_ID 0x20
 #define GLOBAL_FAULT 0xc850
@@ -284,6 +292,16 @@ int aquantia_config(struct phy_device *phydev)
                        phy_write(phydev, MDIO_MMD_PMAPMD, MII_BMCR,
                                  AQUNTIA_SPEED_LSB_MASK |
                                  AQUNTIA_SPEED_MSB_MASK);
+
+               val = phy_read(phydev, MDIO_MMD_PHYXS,
+                              AQUANTIA_SYSTEM_INTERFACE_SR);
+               /* If SI is USXGMII then start USXGMII autoneg */
+               if ((val & AQUANTIA_SI_IN_USE_MASK) == AQUANTIA_SI_USXGMII) {
+                       phy_write(phydev, MDIO_MMD_PHYXS,
+                                 AQUANTIA_VENDOR_PROVISIONING_REG,
+                                 AQUANTIA_USX_AUTONEG_CONTROL_ENA);
+               }
+
        } else if (phydev->interface == PHY_INTERFACE_MODE_SGMII_2500) {
                /* 2.5GBASE-T mode */
                phydev->advertising = SUPPORTED_1000baseT_Full;