sunxi: Enable EMAC on the Bananapi M3

The Bananapi M3 has an RTL8211E PHY connected to the EMAC using
RGMII. The PHY is powered by DCDC1 through SW @ 3.3V.

The board is designed to use 3.3V with RGMII, instead of the standard
reduced voltage of 2.5V we see everywhere. DLDO3, which provides the
I/O voltages, is raised to match.

This patch enables the EMAC and Realtek PHY drivers in the defconfig.
The device tree file already has the EMAC enabled.

Signed-off-by: Chen-Yu Tsai <wens@csie.org>
Reviewed-by: Jagan Teki <jagan@amarulasolutions.com>

diff --git a/configs/Sinovoip_BPI_M3_defconfig b/configs/Sinovoip_BPI_M3_defconfig
index 79743a9c9a51b0e3082ac721cd00b5fec5f68125..b9ab00cb8a295f2360aec785c11bc6b89a8c7a7d 100644 (file)
--- a/configs/Sinovoip_BPI_M3_defconfig
+++ b/configs/Sinovoip_BPI_M3_defconfig
@@ -21,8 +21,10 @@ CONFIG_CONSOLE_MUX=y
 # CONFIG_SPL_DOS_PARTITION is not set
 # CONFIG_SPL_EFI_PARTITION is not set
 CONFIG_DEFAULT_DEVICE_TREE="sun8i-a83t-bananapi-m3"
+CONFIG_PHY_REALTEK=y
+CONFIG_SUN8I_EMAC=y
 CONFIG_AXP_DCDC5_VOLT=1200
-CONFIG_AXP_DLDO3_VOLT=2500
+CONFIG_AXP_DLDO3_VOLT=3300
 CONFIG_AXP_SW_ON=y
 CONFIG_USB_EHCI_HCD=y
 CONFIG_USB_OHCI_HCD=y