xpedite1k: Add support for additional GPIO pins

Enable GPIO pins for an I2C EEPROM write protect, a system reset pin,
and a PMC #MONARCH pin.  These pins are not currently used in U-Boot,
but are used in OSes and may be used in U-Boot in the future.

Signed-off-by: Peter Tyser <ptyser@xes-inc.com>
Signed-off-by: Stefan Roese <sr@denx.de>

diff --git a/board/xpedite1k/xpedite1k.c b/board/xpedite1k/xpedite1k.c
index 8a3503dd4f0c847d88e0a3742f408bf340e58230..ed864bad6e910c8c341d0f9528542f7deda696ef 100644 (file)
--- a/board/xpedite1k/xpedite1k.c
+++ b/board/xpedite1k/xpedite1k.c
@@ -32,9 +32,18 @@ int board_early_init_f(void)
 {
        unsigned long sdrreg;
 
-       /* TBS: Setup the GPIO access for the user LEDs */
+       /*
+        * Enable GPIO for pins 18 - 24
+        * 18 = SEEPROM_WP
+        * 19 = #M_RST
+        * 20 = #MONARCH
+        * 21 = #LED_ALARM
+        * 22 = #LED_ACT
+        * 23 = #LED_STATUS1
+        * 24 = #LED_STATUS2
+        */
        mfsdr(sdr_pfc0, sdrreg);
-       mtsdr(sdr_pfc0, (sdrreg & ~0x00000100) | 0x00000E00);
+       mtsdr(sdr_pfc0, (sdrreg & ~SDR0_PFC0_TRE_ENABLE) | 0x00003e00);
        out32(CONFIG_SYS_GPIO_BASE + 0x018, (USR_LED0 | USR_LED1 | USR_LED2 | USR_LED3));
        LED0_OFF();
        LED1_OFF();