mmc: zynq_sdhci: Wait till sd card detect state is stable

As per SD spec when SD host controller is reset, it takes 1000msec
to detect the card state. In case, if we enable the sd bus voltage &
card detect state is not stable, then host controller will disable
the sd bus voltage.

In case of warm/subsystem reboot, due to unstable card detect state
host controller is disabling the sd bus voltage to sd card causing
sd card timeout error. So we wait for a maximum of 1000msec to get
the card detect state stable before we enable the sd bus voltage.

This current fix is workaround for now, this needs to be analysed
further. Zynqmp platform should behave the same as Versal, but we
did not encounter this issue as of now. So we are fixing it for
Versal only.

Signed-off-by: T Karthik Reddy <t.karthik.reddy@xilinx.com>
Signed-off-by: Ashok Reddy Soma <ashok.reddy.soma@xilinx.com>
Reviewed-by: Jaehoon Chung <jh80.chung@samsung.com>
Signed-off-by: Michal Simek <michal.simek@xilinx.com>

diff --git a/drivers/mmc/zynq_sdhci.c b/drivers/mmc/zynq_sdhci.c
index 9a1693940a792ba3dbd9520546b7e8f97bdfb1ca..4a877b4ce8c817c8e95ab926d063e70274e94b7d 100644 (file)
--- a/drivers/mmc/zynq_sdhci.c
+++ b/drivers/mmc/zynq_sdhci.c
@@ -776,6 +776,25 @@ static int arasan_sdhci_probe(struct udevice *dev)
                return ret;
        upriv->mmc = host->mmc;
 
+       /*
+        * WORKAROUND: Versal platforms have an issue with card detect state.
+        * Due to this, host controller is switching off voltage to sd card
+        * causing sd card timeout error. Workaround this by adding a wait for
+        * 1000msec till the card detect state gets stable.
+        */
+       if (IS_ENABLED(CONFIG_ARCH_VERSAL)) {
+               u32 timeout = 1000;
+
+               while (((sdhci_readl(host, SDHCI_PRESENT_STATE) &
+                        SDHCI_CARD_STATE_STABLE) == 0) && timeout--) {
+                       mdelay(1);
+               }
+               if (!timeout) {
+                       dev_err(dev, "Sdhci card detect state not stable\n");
+                       return -ETIMEDOUT;
+               }
+       }
+
        return sdhci_probe(dev);
 }