xtract_omap730p2 = $(subst _cs0boot,,$(subst _cs3boot,, $(subst _config,,$1)))
at91cap9adk_config : unconfig
- @$(MKCONFIG) $(@:_config=) arm arm926ejs at91cap9adk atmel at91cap9
+ @$(MKCONFIG) $(@:_config=) arm arm926ejs at91cap9adk atmel at91sam9
at91rm9200dk_config : unconfig
@$(MKCONFIG) $(@:_config=) arm arm920t at91rm9200dk atmel at91rm9200
*/
#include <common.h>
-#include <asm/arch/AT91CAP9.h>
+#include <asm/arch/hardware.h>
extern int macb_eth_initialize(int id, void *regs, unsigned int phy_addr);
#if defined(CONFIG_MACB) && defined(CONFIG_CMD_NET)
-void at91cap9_eth_initialize(bd_t *bi)
+void at91sam9_eth_initialize(bd_t *bi)
{
macb_eth_initialize(0, (void *)AT91C_BASE_MACB, 0x00);
}
/*
- * AT91CAP9 setup stuff
+ * AT91CAP9/SAM9 setup stuff
*
* (C) Copyright 2007-2008
* Stelian Pop <stelian.pop <at> leadtechdesign.com>
#include <asm/arch/hardware.h>
/*
- * We're using the AT91CAP9 PITC in 32 bit mode, by
+ * We're using the AT91CAP9/SAM9 PITC in 32 bit mode, by
* setting the 20 bit counter period to its maximum (0xfffff).
*/
#define TIMER_LOAD_VAL 0xfffff
}
/*
- * Reset the cpu by setting up the watchdog timer and let him time out
- * on the AT91CAP9ADK board
+ * Reset the cpu by setting up the watchdog timer and let him time out.
*/
void reset_cpu(ulong ignored)
{
#include <common.h>
#if defined(CONFIG_USB_OHCI_NEW) && defined(CFG_USB_OHCI_CPU_INIT)
-#ifdef CONFIG_AT91CAP9
#include <asm/arch/hardware.h>
return usb_cpu_stop();
}
-#endif /* CONFIG_AT91CAP9 */
#endif /* defined(CONFIG_USB_OHCI) && defined(CFG_USB_OHCI_CPU_INIT) */
extern int atngw100_eth_initialize(bd_t *);
extern int mcffec_initialize(bd_t*);
extern int mcdmafec_initialize(bd_t*);
-extern int at91cap9_eth_initialize(bd_t *);
+extern int at91sam9_eth_initialize(bd_t *);
#ifdef CONFIG_API
extern void (*push_packet)(volatile void *, int);
mcdmafec_initialize(bis);
#endif
#if defined(CONFIG_AT91CAP9)
- at91cap9_eth_initialize(bis);
+ at91sam9_eth_initialize(bis);
#endif
if (!eth_devices) {