armv8: fsl-lsch3: Rewrite comment for stream IDs

LS2080a, LS1088a and LS2088a SOCs are based on Chassis-3 and shared
same stream-id partitioning. This patch rewords the definition to
support all these SOCs.

Also have changes in description about iommu-map property updates
in PCI node.

Signed-off-by: Bharat Bhushan <Bharat.Bhushan@nxp.com>
Reviewed-by: York Sun <york.sun@nxp.com>

diff --git a/arch/arm/include/asm/arch-fsl-layerscape/stream_id_lsch3.h b/arch/arm/include/asm/arch-fsl-layerscape/stream_id_lsch3.h
index ee28323f8ca629c1809298b1a4ff068dc64057d9..d7d527d8f4f34bea1ead14762550e4c8339f113b 100644 (file)
--- a/arch/arm/include/asm/arch-fsl-layerscape/stream_id_lsch3.h
+++ b/arch/arm/include/asm/arch-fsl-layerscape/stream_id_lsch3.h
@@ -8,11 +8,11 @@
 #define __FSL_STREAM_ID_H
 
 /*
- * Stream IDs on ls2080a devices are not hardwired and are
- * programmed by sw.  There are a limited number of stream IDs
- * available, and the partitioning of them is scenario dependent.
- * This header defines the partitioning between legacy, PCI,
- * and DPAA2 devices.
+ * Stream IDs on NXP Chassis-3 (for example ls2080a, ls1088a, ls2088a)
+ * devices are not hardwired and are programmed by sw. There are a limited
+ * number of stream IDs available, and the partitioning of them is scenario
+ * dependent. This header defines the partitioning between legacy,
+ * PCI, and DPAA2 devices.
  *
  * This partitioning can be customized in this file depending
  * on the specific hardware config:
@@ -29,6 +29,9 @@
  *         -set a msi-map entry in the PEXn controller node in the
  *          device tree (see Documentation/devicetree/bindings/pci/pci-msi.txt
  *          for more info on the msi-map definition)
+ *         -set a iommu-map entry in the PEXn controller node in the
+ *          device tree (see Documentation/devicetree/bindings/pci/pci-iommu.txt
+ *          for more info on the iommu-map definition)
  *
  *  -DPAA2
  *     -u-boot will allocate a range of stream IDs to be used by the Management
@@ -36,7 +39,7 @@
  *     -the MC is responsible for allocating and setting up 'isolation context
  *      IDs (ICIDs) based on the allocated stream IDs for all DPAA2 devices.
  *
- * On ls2080a SoCs stream IDs are programmed in AMQ registers (32-bits) for
+ * On Chasis-3 SoCs stream IDs are programmed in AMQ registers (32-bits) for
  * each of the different bus masters.  The relationship between
  * the AMQ registers and stream IDs is defined in the table below:
  *          AMQ bit    streamID bit