arm/km: ethernet support for mgcoge3un

The phy is also configured with "RGMII clock transitions when data
stable" and "Class A driver for the direct backplane connection".

Signed-off-by: Valentin Longchamp <valentin.longchamp@keymile.com>
Signed-off-by: Holger Brunck <holger.brunck@keymile.com>
cc: Prafulla Wadaskar <prafulla@marvell.com>
cc: Heiko Schocher <hs@denx.de>

diff --git a/board/keymile/km_arm/km_arm.c b/board/keymile/km_arm/km_arm.c
index d86acc9d04ba9856141c292e61d279c192a31198..ed6ede3251b6d783764c756b08185d327471906f 100644 (file)
--- a/board/keymile/km_arm/km_arm.c
+++ b/board/keymile/km_arm/km_arm.c
@@ -335,7 +335,42 @@ void dram_init_banksize(void)
        }
 }
 
-/* Configure and enable MV88E1118 PHY */
+#if defined(CONFIG_MGCOGE3UN)
+
+#define        PHY_LED_SEL     0x18
+#define PHY_LED0_LINK  (0x5)
+#define PHY_LED1_ACT   (0x8<<4)
+#define PHY_LED2_INT   (0xe<<8)
+#define        PHY_SPEC_CTRL   0x1c
+#define PHY_RGMII_CLK_STABLE   (0x1<<10)
+#define PHY_CLSA       (0x1<<1)
+
+/* Configure and enable MV88E3018 PHY */
+void reset_phy(void)
+{
+       char *name = "egiga0";
+       unsigned short reg;
+
+       if (miiphy_set_current_dev(name))
+               return;
+
+       /* RGMII clk transition on data stable */
+       if (miiphy_read(name, CONFIG_PHY_BASE_ADR, PHY_SPEC_CTRL, &reg) != 0)
+               printf("Error reading PHY spec ctrl reg\n");
+       if (miiphy_write(name, CONFIG_PHY_BASE_ADR, PHY_SPEC_CTRL,
+               reg | PHY_RGMII_CLK_STABLE | PHY_CLSA) != 0)
+               printf("Error writing PHY spec ctrl reg\n");
+
+       /* leds setup */
+       if (miiphy_write(name, CONFIG_PHY_BASE_ADR, PHY_LED_SEL,
+               PHY_LED0_LINK | PHY_LED1_ACT | PHY_LED2_INT) != 0)
+               printf("Error writing PHY LED reg\n");
+
+       /* reset the phy */
+       miiphy_reset(name, CONFIG_PHY_BASE_ADR);
+}
+#else
+/* Configure and enable MV88E1118 PHY on the piggy*/
 void reset_phy(void)
 {
        char *name = "egiga0";
@@ -346,6 +381,8 @@ void reset_phy(void)
        /* reset the phy */
        miiphy_reset(name, CONFIG_PHY_BASE_ADR);
 }
+#endif
+
 
 #if defined(CONFIG_HUSH_INIT_VAR)
 int hush_init_var(void)