tegra: gpio: Show the GPIO value for outputs

The tegra GPIO controller has two ways of reading the value of a GPIO. It
can supply the 'input' value (which is the value read from the pin) and the
'output' value (which is the value being driven from the pin. With a GPIO
set to output mode, the 'input' value is always low which is not very
useful.

This has the unfortunate result that setting a GPIO high still leaves it
showing as low in the 'gpio status' command.

Adjust the driver to check which direction the GPIO is set to, then read
the value from the appropriate register: 'input' for input GPIOs, 'output'
for output GPIOs.

Signed-off-by: Simon Glass <sjg@chromium.org>
Reviewed-by: Joe Hershberger <joe.hershberger@ni.com>
Signed-off-by: Tom Warren <twarren@nvidia.com>

diff --git a/drivers/gpio/tegra_gpio.c b/drivers/gpio/tegra_gpio.c
index 8e880e276f0a9915a22095b043820996e3a32c81..5a031159ca370c423455e0fdebcf8965dc8fb962 100644 (file)
--- a/drivers/gpio/tegra_gpio.c
+++ b/drivers/gpio/tegra_gpio.c
@@ -177,7 +177,10 @@ static int tegra_gpio_get_value(struct udevice *dev, unsigned offset)
        debug("%s: pin = %d (port %d:bit %d)\n", __func__,
              gpio, GPIO_FULLPORT(gpio), GPIO_BIT(gpio));
 
-       val = readl(&state->bank->gpio_in[GPIO_PORT(gpio)]);
+       if (get_direction(gpio) == DIRECTION_INPUT)
+               val = readl(&state->bank->gpio_in[GPIO_PORT(gpio)]);
+       else
+               val = readl(&state->bank->gpio_out[GPIO_PORT(gpio)]);
 
        return (val >> GPIO_BIT(gpio)) & 1;
 }