imx8qm_dmsse20a1: Improve SPL memory configuration

Currently, building imx8qm_dmsse20a1_defconfig leads to the following
warning:

aarch64-linux-ld.bfd: invalid origin for memory region .sdram

Fix it by using the same SPL memory layout as done in the imx8mq_evk.

Reported-by: Tom Rini <trini@konsulko.com>
Signed-off-by: Fabio Estevam <festevam@denx.de>
Tested-by: Oliver Graute <oliver.graute@kococonnector.com>

diff --git a/configs/imx8qm_dmsse20a1_defconfig b/configs/imx8qm_dmsse20a1_defconfig
index 01eabc43fb37a040dc32c1e3a16621246c5086bf..017a5419134a39ca205dd7d2afc6136ab54eb430 100644 (file)
--- a/configs/imx8qm_dmsse20a1_defconfig
+++ b/configs/imx8qm_dmsse20a1_defconfig
@@ -20,6 +20,7 @@ CONFIG_TARGET_IMX8QM_DMSSE20_A1=y
 CONFIG_SPL_MMC=y
 CONFIG_SPL_SERIAL=y
 CONFIG_SPL_DRIVERS_MISC=y
+CONFIG_SPL_STACK=0x13e000
 CONFIG_SPL=y
 CONFIG_SYS_LOAD_ADDR=0x80280000
 CONFIG_REMAKE_ELF=y
@@ -32,8 +33,16 @@ CONFIG_USE_BOOTCOMMAND=y
 CONFIG_BOOTCOMMAND="mmc dev ${mmcdev}; if mmc rescan; then if run loadbootscript; then run bootscript; else if run loadimage; then run mmcboot; else run netboot; fi; fi; else booti ${loadaddr} - ${fdt_addr}; fi"
 CONFIG_LOG=y
 # CONFIG_DISPLAY_CPUINFO is not set
+CONFIG_SPL_SYS_MALLOC_SIMPLE=y
+# CONFIG_SPL_SHARES_INIT_SP_ADDR is not set
+CONFIG_SPL_SYS_MALLOC=y
+CONFIG_SPL_HAS_CUSTOM_MALLOC_START=y
+CONFIG_SPL_CUSTOM_SYS_MALLOC_ADDR=0x120000
+CONFIG_SPL_SYS_MALLOC_SIZE=0x3000
 CONFIG_BOARD_EARLY_INIT_F=y
 CONFIG_SPL_MAX_SIZE=0x1f000
+CONFIG_SPL_HAS_BSS_LINKER_SECTION=y
+CONFIG_SPL_BSS_START_ADDR=0x128000
 CONFIG_SPL_BSS_MAX_SIZE=0x1000
 CONFIG_SPL_BOARD_INIT=y
 CONFIG_SPL_POWER_DOMAIN=y