dt-bindings: usb: mtk-xhci: Add binding for MediaTek xHCI host controller

Add dt-binding for MediaTek xHCI host controller

Signed-off-by: Chunfeng Yun <chunfeng.yun@mediatek.com>
Signed-off-by: Frank Wunderlich <frank-w@public-files.de>
Reviewed-by: Weijie Gao <weijie.gao@mediatek.com>

diff --git a/doc/device-tree-bindings/usb/mediatek,mtk-xhci.txt b/doc/device-tree-bindings/usb/mediatek,mtk-xhci.txt
new file mode 100644 (file)
index 0000000..0447468
--- /dev/null
+++ b/doc/device-tree-bindings/usb/mediatek,mtk-xhci.txt
@@ -0,0 +1,40 @@
+MediaTek xHCI
+
+The device node for USB3 host controller on MediaTek SoCs.
+
+Required properties:
+ - compatible : should be "mediatek,mtk-xhci"
+ - reg : specifies physical base address and size of the registers
+ - reg-names: should be "mac" for xHCI MAC and "ippc" for IP port control
+ - power-domains : a phandle to USB power domain node to control USB's
+       MTCMOS
+ - vusb33-supply : regulator of USB avdd3.3v
+
+ - clocks : a list of phandle + clock-specifier pairs, one for each
+       entry in clock-names
+ - clock-names : must contain
+       "sys_ck": controller clock used by normal mode,
+       the following ones are optional:
+       "ref_ck": reference clock used by low power mode etc,
+       "mcu_ck": mcu_bus clock for register access,
+       "dma_ck": dma_bus clock for data transfer by DMA,
+       "xhci_ck": controller clock
+
+ - phys : list of all the USB PHYs on this HCD
+ - phy-names: name specifier for the USB PHY
+
+Optional properties:
+ - vbus-supply : reference to the VBUS regulator;
+
+Example:
+xhci: usb@1a0c0000 {
+       compatible = "mediatek,mt7629-xhci", "mediatek,mtk-xhci";
+       reg = <0x1a0c0000 0x1000>, <0x1a0c3e00 0x0100>;
+       reg-names = "mac", "ippc";
+       power-domains = <&scpsys MT7629_POWER_DOMAIN_HIF1>;
+       clocks = <&ssusbsys CLK_SSUSB_SYS_EN>, <&ssusbsys CLK_SSUSB_REF_EN>,
+                <&ssusbsys CLK_SSUSB_MCU_EN>, <&ssusbsys CLK_SSUSB_DMA_EN>;
+       clock-names = "sys_ck", "ref_ck", "mcu_ck", "dma_ck";
+       phys = <&u2port0 PHY_TYPE_USB2>, <&u3port0 PHY_TYPE_USB3>;
+       status = "disabled";
+};