arm64: zynqmp: Fix usb reset over bootmode pins on zcu100

The commit a4180c369607 ("arm64: zynqmp: Add mode-pin GPIO controller DT
node") added usb phy reset over bootmode pins by default on usb0 only.
zcu100 is using usb0 as peripheral and usb1 as host. Unfortunately reset
line is shared for both usb ulpi phys but usb_rst_b is connected to usb5744
hub which is used only in host mode. Especially this chip requires reset to
operate properly that's why better assign gpio reset to usb1 instead of
usb0.
Without this change usb start crashed when runs.

Signed-off-by: Michal Simek <michal.simek@amd.com>
Link: https://lore.kernel.org/r/1ca80ec5bf7a595c03822f3e4e3683298205067a.1688992653.git.michal.simek@amd.com

diff --git a/arch/arm/dts/zynqmp-zcu100-revC.dts b/arch/arm/dts/zynqmp-zcu100-revC.dts
index 78c3250760067a4734099ddbaa17b17f5f47039f..a84cd86694e28a80d552477e1c4ae491bd908493 100644 (file)
--- a/arch/arm/dts/zynqmp-zcu100-revC.dts
+++ b/arch/arm/dts/zynqmp-zcu100-revC.dts
@@ -569,6 +569,7 @@
        pinctrl-0 = <&pinctrl_usb0_default>;
        phy-names = "usb3-phy";
        phys = <&psgtr 2 PHY_TYPE_USB3 0 0>;
+       /delete-property/ reset-gpios;
 };
 
 &dwc3_0 {
@@ -584,6 +585,7 @@
        pinctrl-0 = <&pinctrl_usb1_default>;
        phy-names = "usb3-phy";
        phys = <&psgtr 3 PHY_TYPE_USB3 1 0>;
+       reset-gpios = <&modepin_gpio 1 GPIO_ACTIVE_LOW>;
 };
 
 &dwc3_1 {