net: zynq: Add support for different PHY interface types

MII is setup by default for all cases. The most of boards are using
RGMII but PHY drivers are not doing any specific setting that's why MII
setting was working fine. With TI DP83867 is necessary to setup
paramaters based on interface type.

Use one setting per board for it which is something what will be removed
when driver is moved to DM.

Signed-off-by: Michal Simek <michal.simek@xilinx.com>
Acked-by: Joe Hershberger <joe.hershberger@ni.com>

diff --git a/drivers/net/zynq_gem.c b/drivers/net/zynq_gem.c
index e3af8dc930fd0ab706131e8b7e5c19a910146985..ac3dd8b70fe78d7f73766a1798bba0f95b310e13 100644 (file)
--- a/drivers/net/zynq_gem.c
+++ b/drivers/net/zynq_gem.c
@@ -156,6 +156,7 @@ struct zynq_gem_priv {
        int phyaddr;
        u32 emio;
        int init;
+       phy_interface_t interface;
        struct phy_device *phydev;
        struct mii_dev *bus;
 };
@@ -359,7 +360,7 @@ static int zynq_gem_init(struct eth_device *dev, bd_t * bis)
 
        /* interface - look at tsec */
        phydev = phy_connect(priv->bus, priv->phyaddr, dev,
-                            PHY_INTERFACE_MODE_MII);
+                            priv->interface);
 
        phydev->supported = supported | ADVERTISED_Pause |
                            ADVERTISED_Asym_Pause;
@@ -546,6 +547,12 @@ int zynq_gem_initialize(bd_t *bis, phys_addr_t base_addr,
        priv->phyaddr = phy_addr;
        priv->emio = emio;
 
+#ifndef CONFIG_ZYNQ_GEM_INTERFACE
+       priv->interface = PHY_INTERFACE_MODE_MII;
+#else
+       priv->interface = CONFIG_ZYNQ_GEM_INTERFACE;
+#endif
+
        sprintf(dev->name, "Gem.%lx", base_addr);
 
        dev->iobase = base_addr;