select SYSCOUNTER_TIMER
select SYS_L2CACHE_OFF
+config MX6_OCRAM_256KB
+ bool "Support 256KB OCRAM"
+ depends on MX6D || MX6Q
+ help
+ Allows using the full 256KB size of the OCRAM on the MX6Q/MX6D series
+ of chips, such as for SPL. The OCRAM of the Lite series of chips is
+ only 128KB, so using this option will prevent the resulting code from
+ working on those chips.
+
config MX6_DDRCAL
bool "Include dynamic DDR calibration routines"
depends on SPL
config SPL_SIZE_LIMIT
int "Maximum size of SPL image"
depends on SPL
- default 69632 if ARCH_MX6
+ default 69632 if ARCH_MX6 && !MX6_OCRAM_256KB
+ default 200704 if ARCH_MX6 && MX6_OCRAM_256KB
default 0
help
Specifies the maximum length of the U-Boot SPL image.
#define __IMX6_SPL_CONFIG_H
#ifdef CONFIG_SPL
+
+#ifdef CONFIG_MX6_OCRAM_256KB
/*
- * see Figure 8-3 in IMX6DQ/IMX6SDL Reference manuals:
+ * see Figure 8.4.1 in IMX6DQ Reference manuals:
+ * - IMX6DQ OCRAM (IRAM) is from 0x00907000 to 0x0093FFFF
+ * - BOOT ROM stack is at 0x0093FFB8
+ * - if icache/dcache is enabled (eFuse/strapping controlled) then the
+ * IMX BOOT ROM will setup MMU table at 0x00938000, therefore we need to
+ * fit between 0x00907000 and 0x00938000.
+ * - Additionally the BOOT ROM loads what they consider the firmware image
+ * which consists of a 4K header in front of us that contains the IVT, DCD
+ * and some padding thus 'our' max size is really 0x00908000 - 0x00938000
+ * or 192KB
+ */
+#define CONFIG_SPL_MAX_SIZE 0x30000
+#define CONFIG_SPL_STACK 0x0093FFB8
+/*
+ * Pad SPL to 196KB (4KB header + 192KB max size). This allows to write the
+ * SPL/U-Boot combination generated with u-boot-with-spl.imx directly to a
+ * boot media (given that boot media specific offset is configured properly).
+ */
+#define CONFIG_SPL_PAD_TO 0x31000
+#else
+/*
+ * see Figure 8-3 in IMX6SDL Reference manuals:
* - IMX6SDL OCRAM (IRAM) is from 0x00907000 to 0x0091FFFF
- * - IMX6DQ has 2x IRAM of IMX6SDL but we intend to support IMX6SDL as well
* - BOOT ROM stack is at 0x0091FFB8
* - if icache/dcache is enabled (eFuse/strapping controlled) then the
* IMX BOOT ROM will setup MMU table at 0x00918000, therefore we need to
*/
#define CONFIG_SPL_PAD_TO 0x11000
+#endif
+
/* MMC support */
#if defined(CONFIG_SPL_MMC_SUPPORT)
#define CONFIG_SYS_MMCSD_FS_BOOT_PARTITION 1