--- /dev/null
+// SPDX-License-Identifier: (GPL-2.0+ OR BSD-3-Clause)
+/*
+ * Copyright (c) STMicroelectronics 2019 - All Rights Reserved
+ * Copyright (c) 2020 Engicam srl
+ * Copyright (c) 2020 Amarula Solutons(India)
+ */
+
+/dts-v1/;
+#include "stm32mp157.dtsi"
+#include "stm32mp157a-microgea-stm32mp1.dtsi"
+#include "stm32mp15-pinctrl.dtsi"
+#include "stm32mp15xxaa-pinctrl.dtsi"
+#include <dt-bindings/gpio/gpio.h>
+
+/ {
+ model = "Engicam MicroGEA STM32MP1 MicroDev 2.0 7\" Open Frame";
+ compatible = "engicam,microgea-stm32mp1-microdev2.0-of7",
+ "engicam,microgea-stm32mp1", "st,stm32mp157";
+
+ aliases {
+ serial0 = &uart4;
+ serial1 = &uart8;
+ };
+
+ chosen {
+ stdout-path = "serial0:115200n8";
+ };
+
+ backlight: backlight {
+ compatible = "gpio-backlight";
+ gpios = <&gpiod 13 GPIO_ACTIVE_HIGH>;
+ default-on;
+ };
+
+ lcd_3v3: regulator-lcd-3v3 {
+ compatible = "regulator-fixed";
+ regulator-name = "lcd_3v3";
+ regulator-min-microvolt = <3300000>;
+ regulator-max-microvolt = <3300000>;
+ gpio = <&gpiof 10 GPIO_ACTIVE_HIGH>;
+ enable-active-high;
+ regulator-always-on;
+ power-supply = <&panel_pwr>;
+ };
+
+ panel_pwr: regulator-panel-pwr {
+ compatible = "regulator-fixed";
+ regulator-name = "panel_pwr";
+ regulator-min-microvolt = <3300000>;
+ regulator-max-microvolt = <3300000>;
+ gpio = <&gpiob 10 GPIO_ACTIVE_HIGH>;
+ regulator-always-on;
+ };
+
+ panel {
+ compatible = "auo,b101aw03";
+ backlight = <&backlight>;
+ enable-gpios = <&gpiof 2 GPIO_ACTIVE_HIGH>;
+ power-supply = <&lcd_3v3>;
+
+ port {
+ panel_in: endpoint {
+ remote-endpoint = <<dc_ep0_out>;
+ };
+ };
+ };
+};
+
+&i2c2 {
+ i2c-scl-falling-time-ns = <20>;
+ i2c-scl-rising-time-ns = <185>;
+ pinctrl-names = "default", "sleep";
+ pinctrl-0 = <&i2c2_pins_a>;
+ pinctrl-1 = <&i2c2_sleep_pins_a>;
+ status = "okay";
+};
+
+<dc {
+ pinctrl-names = "default";
+ pinctrl-0 = <<dc_pins>;
+ status = "okay";
+
+ port {
+ ltdc_ep0_out: endpoint@0 {
+ reg = <0>;
+ remote-endpoint = <&panel_in>;
+ };
+ };
+};
+
+&pinctrl {
+ ltdc_pins: ltdc {
+ pins {
+ pinmux = <STM32_PINMUX('G', 10, AF14)>, /* LTDC_B2 */
+ <STM32_PINMUX('H', 12, AF14)>, /* LTDC_R6 */
+ <STM32_PINMUX('H', 11, AF14)>, /* LTDC_R5 */
+ <STM32_PINMUX('D', 10, AF14)>, /* LTDC_B3 */
+ <STM32_PINMUX('D', 9, AF14)>, /* LTDC_B0 */
+ <STM32_PINMUX('E', 5, AF14)>, /* LTDC_G0 */
+ <STM32_PINMUX('E', 6, AF14)>, /* LTDC_G1 */
+ <STM32_PINMUX('E', 13, AF14)>, /* LTDC_DE */
+ <STM32_PINMUX('E', 15, AF14)>, /* LTDC_R7 */
+ <STM32_PINMUX('G', 7, AF14)>, /* LTDC_CLK */
+ <STM32_PINMUX('G', 12, AF14)>, /* LTDC_B1 */
+ <STM32_PINMUX('H', 2, AF14)>, /* LTDC_R0 */
+ <STM32_PINMUX('H', 3, AF14)>, /* LTDC_R1 */
+ <STM32_PINMUX('H', 8, AF14)>, /* LTDC_R2 */
+ <STM32_PINMUX('H', 9, AF14)>, /* LTDC_R3 */
+ <STM32_PINMUX('H', 10, AF14)>, /* LTDC_R4 */
+ <STM32_PINMUX('H', 13, AF14)>, /* LTDC_G2 */
+ <STM32_PINMUX('H', 14, AF14)>, /* LTDC_G3 */
+ <STM32_PINMUX('H', 15, AF14)>, /* LTDC_G4 */
+ <STM32_PINMUX('I', 0, AF14)>, /* LTDC_G5 */
+ <STM32_PINMUX('I', 1, AF14)>, /* LTDC_G6 */
+ <STM32_PINMUX('I', 2, AF14)>, /* LTDC_G7 */
+ <STM32_PINMUX('I', 4, AF14)>, /* LTDC_B4 */
+ <STM32_PINMUX('I', 5, AF14)>, /* LTDC_B5 */
+ <STM32_PINMUX('B', 8, AF14)>, /* LTDC_B6 */
+ <STM32_PINMUX('I', 7, AF14)>, /* LTDC_B7 */
+ <STM32_PINMUX('I', 9, AF14)>, /* LTDC_VSYNC */
+ <STM32_PINMUX('I', 10, AF14)>; /* LTDC_HSYNC */
+ bias-disable;
+ drive-push-pull;
+ slew-rate = <3>;
+ };
+ };
+};
+
+&sdmmc1 {
+ bus-width = <4>;
+ disable-wp;
+ pinctrl-names = "default", "opendrain", "sleep";
+ pinctrl-0 = <&sdmmc1_b4_pins_a>;
+ pinctrl-1 = <&sdmmc1_b4_od_pins_a>;
+ pinctrl-2 = <&sdmmc1_b4_sleep_pins_a>;
+ st,neg-edge;
+ vmmc-supply = <&vdd>;
+ status = "okay";
+};
+
+&uart4 {
+ pinctrl-names = "default", "sleep", "idle";
+ pinctrl-0 = <&uart4_pins_a>;
+ pinctrl-1 = <&uart4_sleep_pins_a>;
+ pinctrl-2 = <&uart4_idle_pins_a>;
+ status = "okay";
+};
+
+/* J31: RS323 */
+&uart8 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&uart8_pins_a>;
+ status = "okay";
+};
--- /dev/null
+CONFIG_ARM=y
+CONFIG_ARCH_STM32MP=y
+CONFIG_SYS_MALLOC_F_LEN=0x3000
+CONFIG_SYS_MEMTEST_START=0xc0000000
+CONFIG_SYS_MEMTEST_END=0xc4000000
+CONFIG_ENV_OFFSET=0x280000
+CONFIG_SPL_TEXT_BASE=0x2FFC2500
+CONFIG_SPL_MMC_SUPPORT=y
+CONFIG_SPL=y
+CONFIG_TARGET_MICROGEA_STM32MP1=y
+CONFIG_ENV_OFFSET_REDUND=0x2C0000
+# CONFIG_ARMV7_VIRT is not set
+CONFIG_DEFAULT_DEVICE_TREE="stm32mp157a-microgea-stm32mp1-microdev2.0-of7"
+CONFIG_DISTRO_DEFAULTS=y
+CONFIG_FIT=y
+CONFIG_BOOTCOMMAND="run bootcmd_stm32mp"
+CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_PARTITION=y
+CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_PARTITION=3
+CONFIG_SPL_ENV_SUPPORT=y
+CONFIG_SPL_I2C_SUPPORT=y
+CONFIG_SPL_POWER_SUPPORT=y
+CONFIG_SYS_PROMPT="STM32MP> "
+CONFIG_CMD_ADTIMG=y
+CONFIG_CMD_ERASEENV=y
+CONFIG_CMD_MEMINFO=y
+CONFIG_CMD_MEMTEST=y
+CONFIG_CMD_ADC=y
+CONFIG_CMD_CLK=y
+CONFIG_CMD_FUSE=y
+CONFIG_CMD_GPIO=y
+CONFIG_CMD_I2C=y
+CONFIG_CMD_MMC=y
+CONFIG_CMD_REMOTEPROC=y
+CONFIG_CMD_CACHE=y
+CONFIG_CMD_TIME=y
+CONFIG_CMD_TIMER=y
+CONFIG_CMD_PMIC=y
+CONFIG_CMD_REGULATOR=y
+CONFIG_CMD_EXT4_WRITE=y
+# CONFIG_SPL_DOS_PARTITION is not set
+CONFIG_OF_SPL_REMOVE_PROPS="interrupts interrupt-names interrupts-extended interrupt-controller \\\#interrupt-cells interrupt-parent dmas dma-names assigned-clocks assigned-clock-rates assigned-clock-parents hwlocks"
+CONFIG_ENV_IS_NOWHERE=y
+CONFIG_ENV_IS_IN_MMC=y
+CONFIG_SYS_REDUNDAND_ENVIRONMENT=y
+CONFIG_SYS_RELOC_GD_ENV_ADDR=y
+# CONFIG_SPL_ENV_IS_NOWHERE is not set
+CONFIG_DM_HWSPINLOCK=y
+CONFIG_HWSPINLOCK_STM32=y
+CONFIG_DM_I2C=y
+CONFIG_SYS_I2C_STM32F7=y
+CONFIG_LED=y
+CONFIG_LED_GPIO=y
+CONFIG_DM_MAILBOX=y
+CONFIG_STM32_IPCC=y
+CONFIG_STM32_FMC2_EBI=y
+CONFIG_DM_MMC=y
+CONFIG_SUPPORT_EMMC_BOOT=y
+CONFIG_STM32_SDMMC2=y
+CONFIG_PHY_REALTEK=y
+CONFIG_DM_ETH=y
+CONFIG_DWC_ETH_QOS=y
+CONFIG_PHY=y
+CONFIG_PINCONF=y
+# CONFIG_SPL_PINCTRL_FULL is not set
+CONFIG_PINCTRL_STMFX=y
+CONFIG_DM_PMIC=y
+# CONFIG_SPL_PMIC_CHILDREN is not set
+CONFIG_PMIC_STPMIC1=y
+CONFIG_DM_REGULATOR=y
+CONFIG_DM_REGULATOR_FIXED=y
+CONFIG_DM_REGULATOR_GPIO=y
+CONFIG_REMOTEPROC_STM32_COPRO=y
+CONFIG_DM_RTC=y
+CONFIG_RTC_STM32=y
+CONFIG_SERIAL_RX_BUFFER=y
+CONFIG_WDT=y
+CONFIG_WDT_STM32MP=y
+CONFIG_LZO=y
+CONFIG_ERRNO_STR=y
projects / u-boot.git / commitdiff