mx5: lowlevel_init.S: Fix PLL settings for mx53

mx5: lowlevel_init.S: Fix PLL settings for mx53

Currently PLL2 is not explicitely configured for mx53 and it runs at 333MHz.

Since PLL2 is the parent clock for DDR2, IPU, VPU, we should set it at 400MHz
instead.

Without doing so, it is not possible to use a 2.6.35 FSL kernel and display HDMI
at 1080p because the IPU clock cannot reach the requested frequency.

Set PLL2 to 400MHz, so that 1080p can be played and the DDR2 can run at its
maximum frequency.

Also, setup the other PLL's as done in FSL U-boot and re-arrange the code a little
bit to allow easier comparison with the original clock setup from FSL U-boot.

Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com>