tqma6_mba6: Remove unused defines

The PAD_CTRL definitions are not used anywhere.

Remove them to make the code cleaner.

Signed-off-by: Fabio Estevam <festevam@denx.de>

diff --git a/board/tq/tqma6/tqma6_mba6.c b/board/tq/tqma6/tqma6_mba6.c
index 877539e359e2321201cdb34c78c390f8fb7a04b0..7267d812e7d18461c6631fa487b711abe96cec37 100644 (file)
--- a/board/tq/tqma6/tqma6_mba6.c
+++ b/board/tq/tqma6/tqma6_mba6.c
@@ -34,25 +34,6 @@
 #define UART_PAD_CTRL  (PAD_CTL_PUS_100K_UP | PAD_CTL_SPEED_MED | \
        PAD_CTL_DSE_80ohm   | PAD_CTL_SRE_FAST  | PAD_CTL_HYS)
 
-#define USDHC_CLK_PAD_CTRL (PAD_CTL_PUS_47K_UP  | PAD_CTL_SPEED_LOW | \
-       PAD_CTL_DSE_40ohm   | PAD_CTL_SRE_FAST  | PAD_CTL_HYS)
-
-#define USDHC_PAD_CTRL (PAD_CTL_PUS_47K_UP  | PAD_CTL_SPEED_LOW | \
-       PAD_CTL_DSE_80ohm   | PAD_CTL_SRE_FAST  | PAD_CTL_HYS)
-
-#define GPIO_OUT_PAD_CTRL  (PAD_CTL_PUS_100K_UP | PAD_CTL_SPEED_LOW | \
-       PAD_CTL_DSE_40ohm   | PAD_CTL_HYS)
-
-#define GPIO_IN_PAD_CTRL  (PAD_CTL_PUS_100K_UP | PAD_CTL_SPEED_LOW | \
-       PAD_CTL_DSE_40ohm   | PAD_CTL_HYS)
-
-#define SPI_PAD_CTRL (PAD_CTL_PUS_100K_UP | PAD_CTL_SPEED_MED | \
-       PAD_CTL_DSE_80ohm | PAD_CTL_SRE_FAST | PAD_CTL_HYS)
-
-#define I2C_PAD_CTRL   (PAD_CTL_PUS_100K_UP | PAD_CTL_SPEED_MED | \
-       PAD_CTL_DSE_80ohm | PAD_CTL_HYS |                       \
-       PAD_CTL_ODE | PAD_CTL_SRE_FAST)
-
 #if defined(CONFIG_TQMA6Q)
 
 #define IOMUX_SW_PAD_CTRL_GRP_DDR_TYPE_RGMII   0x02e0790