From: Felipe Balbi Date: Fri, 12 Apr 2024 20:26:02 +0000 (+0200) Subject: usb: dwc3: gadget: clear SUSPHY bit before ep cmds X-Git-Url: http://git.dujemihanovic.xyz/%22http:/www.sics.se/static/git-favicon.png?a=commitdiff_plain;h=967b31c3ccdc09284a4447ebc4577bb7ef06d500;p=u-boot.git usb: dwc3: gadget: clear SUSPHY bit before ep cmds Upstream Linux commit 2b0f11df84bb. Synopsys Databook 2.60a has a note that if we're sending an endpoint command we _must_ make sure that DWC3_GUSB2PHY(n).SUSPHY bit is cleared. This patch implements that particular detail. Signed-off-by: Felipe Balbi Signed-off-by: Alexander Sverdlin Reviewed-by: Mattijs Korpershoek Link: https://lore.kernel.org/r/20240412202611.3565052-3-alexander.sverdlin@siemens.com Signed-off-by: Mattijs Korpershoek --- diff --git a/drivers/usb/dwc3/gadget.c b/drivers/usb/dwc3/gadget.c index b4cc238fa1..06a29ed864 100644 --- a/drivers/usb/dwc3/gadget.c +++ b/drivers/usb/dwc3/gadget.c @@ -301,8 +301,25 @@ int dwc3_send_gadget_ep_cmd(struct dwc3 *dwc, unsigned ep, { u32 timeout = 500; u32 reg; + + int susphy = false; int ret = -EINVAL; + /* + * Synopsys Databook 2.60a states, on section 6.3.2.5.[1-8], that if + * we're issuing an endpoint command, we must check if + * GUSB2PHYCFG.SUSPHY bit is set. If it is, then we need to clear it. + * + * We will also set SUSPHY bit to what it was before returning as stated + * by the same section on Synopsys databook. + */ + reg = dwc3_readl(dwc->regs, DWC3_GUSB2PHYCFG(0)); + if (unlikely(reg & DWC3_GUSB2PHYCFG_SUSPHY)) { + susphy = true; + reg &= ~DWC3_GUSB2PHYCFG_SUSPHY; + dwc3_writel(dwc->regs, DWC3_GUSB2PHYCFG(0), reg); + } + dwc3_writel(dwc->regs, DWC3_DEPCMDPAR0(ep), params->param0); dwc3_writel(dwc->regs, DWC3_DEPCMDPAR1(ep), params->param1); dwc3_writel(dwc->regs, DWC3_DEPCMDPAR2(ep), params->param2); @@ -330,6 +347,12 @@ int dwc3_send_gadget_ep_cmd(struct dwc3 *dwc, unsigned ep, udelay(1); } while (1); + if (unlikely(susphy)) { + reg = dwc3_readl(dwc->regs, DWC3_GUSB2PHYCFG(0)); + reg |= DWC3_GUSB2PHYCFG_SUSPHY; + dwc3_writel(dwc->regs, DWC3_GUSB2PHYCFG(0), reg); + } + return ret; }