From: Neil Armstrong Date: Tue, 28 May 2024 08:31:55 +0000 (+0200) Subject: pinctrl: qcom: add support setting pin configuration for special pins X-Git-Url: http://git.dujemihanovic.xyz/%22http:/www.sics.se/static/git-favicon.png?a=commitdiff_plain;h=0e044c8098b9b70916d3d2de10958408c6ea95c2;p=u-boot.git pinctrl: qcom: add support setting pin configuration for special pins Use the previously introduced msm_special_pin_data to setup the special pins configuration if the SoC driver have them specified. Signed-off-by: Neil Armstrong Reviewed-by: Sumit Garg --- diff --git a/drivers/pinctrl/qcom/pinctrl-qcom.c b/drivers/pinctrl/qcom/pinctrl-qcom.c index 4f4e9a8394..26a3fba194 100644 --- a/drivers/pinctrl/qcom/pinctrl-qcom.c +++ b/drivers/pinctrl/qcom/pinctrl-qcom.c @@ -103,14 +103,47 @@ static int msm_pinmux_set(struct udevice *dev, unsigned int pin_selector, return 0; } +static int msm_pinconf_set_special(struct msm_pinctrl_priv *priv, unsigned int pin_selector, + unsigned int param, unsigned int argument) +{ + unsigned int offset = pin_selector - priv->data->pin_data.special_pins_start; + const struct msm_special_pin_data *data; + + if (!priv->data->pin_data.special_pins_data) + return 0; + + data = &priv->data->pin_data.special_pins_data[offset]; + + switch (param) { + case PIN_CONFIG_DRIVE_STRENGTH: + argument = (argument / 2) - 1; + clrsetbits_le32(priv->base + data->ctl_reg, + GENMASK(2, 0) << data->drv_bit, + argument << data->drv_bit); + break; + case PIN_CONFIG_BIAS_DISABLE: + clrbits_le32(priv->base + data->ctl_reg, + TLMM_GPIO_PULL_MASK << data->pull_bit); + break; + case PIN_CONFIG_BIAS_PULL_UP: + clrsetbits_le32(priv->base + data->ctl_reg, + TLMM_GPIO_PULL_MASK << data->pull_bit, + argument << data->pull_bit); + break; + default: + return 0; + } + + return 0; +} + static int msm_pinconf_set(struct udevice *dev, unsigned int pin_selector, unsigned int param, unsigned int argument) { struct msm_pinctrl_priv *priv = dev_get_priv(dev); - /* Always NOP for special pins */ if (qcom_is_special_pin(&priv->data->pin_data, pin_selector)) - return 0; + return msm_pinconf_set_special(priv, pin_selector, param, argument); switch (param) { case PIN_CONFIG_DRIVE_STRENGTH: