From: Greg Malysa Date: Tue, 26 Mar 2024 02:28:08 +0000 (-0400) Subject: mmc: Support 32-bit only ADMA on 64-bit platforms X-Git-Url: http://git.dujemihanovic.xyz/%22http:/www.sics.se/static/%7B%7B?a=commitdiff_plain;h=5359cd1135d069a3033bda65d3e72a3c4a76160d;p=u-boot.git mmc: Support 32-bit only ADMA on 64-bit platforms Some arm64 platforms may include SDIO host controllers that only support 32-bit ADMA. While the Linux kernel detects which size is supported and adjusts the descriptor size used dynamically, the previous u-boot implementation statically selected between the two depending on whether DMA_ADDR_T_64BIT was defined. Because the static selection is already in place and effective for most platforms, this patch logically separates "64 bit addresses are used for DMA on this platform" and "64 bit addresses are used by the SDIO host controller for ADMA" in order to support the small number of platforms where these statements are not equivalent. Using 32 bits is opt-in and existing 64 bit platforms should be unaffected by this change. Co-developed-by: Nathan Barrett-Morrison Signed-off-by: Nathan Barrett-Morrison Co-developed-by: Ian Roberts Signed-off-by: Ian Roberts Signed-off-by: Greg Malysa Reviewed-by: Jaehoon Chung --- diff --git a/drivers/mmc/Kconfig b/drivers/mmc/Kconfig index 06e32e7569..549634891a 100644 --- a/drivers/mmc/Kconfig +++ b/drivers/mmc/Kconfig @@ -504,6 +504,24 @@ config SPL_MMC_SDHCI_ADMA This enables support for the ADMA (Advanced DMA) defined in the SD Host Controller Standard Specification Version 3.00 in SPL. +config MMC_SDHCI_ADMA_FORCE_32BIT + bool "Force 32 bit mode for ADMA on 64 bit platforms" + help + This forces SDHCI ADMA to be built for 32 bit descriptors, even + on a 64 bit platform where they would otherwise be assumed to + be 64 bits. This is necessary for certain hardware platforms + that are 64-bit but include only 32-bit support within the selected + SD host controller IP. + +config MMC_SDHCI_ADMA_64BIT + bool "Use SHDCI ADMA with 64 bit descriptors" + depends on !MMC_SDHCI_ADMA_FORCE_32BIT + default y if DMA_ADDR_T_64BIT + help + This selects 64 bit descriptors for SDHCI ADMA. It is enabled by + default on 64 bit systems, but can be disabled if one of these + systems includes 32-bit ADMA. + config FIXED_SDHCI_ALIGNED_BUFFER hex "SDRAM address for fixed buffer" depends on SPL && MVEBU_SPL_BOOT_DEVICE_MMC diff --git a/drivers/mmc/sdhci-adma.c b/drivers/mmc/sdhci-adma.c index 8c38448b6a..283ba956de 100644 --- a/drivers/mmc/sdhci-adma.c +++ b/drivers/mmc/sdhci-adma.c @@ -23,7 +23,7 @@ void sdhci_adma_write_desc(struct sdhci_host *host, void **next_desc, desc->len = len & 0xffff; desc->reserved = 0; desc->addr_lo = lower_32_bits(addr); -#ifdef CONFIG_DMA_ADDR_T_64BIT +#ifdef CONFIG_MMC_SDHCI_ADMA_64BIT desc->addr_hi = upper_32_bits(addr); #endif diff --git a/drivers/mmc/sdhci.c b/drivers/mmc/sdhci.c index 65090348ae..ceeac32882 100644 --- a/drivers/mmc/sdhci.c +++ b/drivers/mmc/sdhci.c @@ -902,11 +902,10 @@ int sdhci_setup_cfg(struct mmc_config *cfg, struct sdhci_host *host, host->adma_addr = virt_to_phys(host->adma_desc_table); } -#ifdef CONFIG_DMA_ADDR_T_64BIT - host->flags |= USE_ADMA64; -#else - host->flags |= USE_ADMA; -#endif + if (IS_ENABLED(CONFIG_MMC_SDHCI_ADMA_64BIT)) + host->flags |= USE_ADMA64; + else + host->flags |= USE_ADMA; #endif if (host->quirks & SDHCI_QUIRK_REG32_RW) host->version = diff --git a/include/sdhci.h b/include/sdhci.h index 2dd13b4c71..78ef0d1c08 100644 --- a/include/sdhci.h +++ b/include/sdhci.h @@ -300,7 +300,7 @@ struct sdhci_ops { }; #define ADMA_MAX_LEN 65532 -#ifdef CONFIG_DMA_ADDR_T_64BIT +#ifdef CONFIG_MMC_SDHCI_ADMA_64BIT #define ADMA_DESC_LEN 16 #else #define ADMA_DESC_LEN 8 @@ -325,7 +325,7 @@ struct sdhci_adma_desc { u8 reserved; u16 len; u32 addr_lo; -#ifdef CONFIG_DMA_ADDR_T_64BIT +#ifdef CONFIG_MMC_SDHCI_ADMA_64BIT u32 addr_hi; #endif } __packed;