From e04072536efcbe504596ea980077eb63c52082b0 Mon Sep 17 00:00:00 2001
From: Steven Lawrance <steven.lawrance@softathome.com>
Date: Thu, 29 Oct 2020 18:27:34 +0100
Subject: [PATCH] drivers: led: bcm6858: set the correct led polarity register

This change sets the output (hardware) polarity register instead of the
input (software) polarity register for the bcm6858 LED controller.  The
logic was inverted (a LED configued active high behaved as active low).

Signed-off-by: Steven Lawrance <steven.lawrance@softathome.com>
Reviewed-by: Philippe Reynes <philippe.reynes@softathome.com>
---
 drivers/led/led_bcm6858.c | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/led/led_bcm6858.c b/drivers/led/led_bcm6858.c
index b415d8b2b4..511185ffad 100644
--- a/drivers/led/led_bcm6858.c
+++ b/drivers/led/led_bcm6858.c
@@ -40,8 +40,8 @@
 #define LED_FLASH_RATE_CONTROL_REG0	0x10
 /* Soft LED input register */
 #define LED_SW_LED_IP_REG		0xb8
-/* Soft LED input polarity register */
-#define LED_SW_LED_IP_PPOL_REG		0xbc
+/* Parallel LED Output Polarity Register */
+#define LED_PLED_OP_PPOL_REG		0xc0
 
 struct bcm6858_led_priv {
 	void __iomem *regs;
@@ -198,9 +198,9 @@ static int bcm6858_led_probe(struct udevice *dev)
 
 		/* configure the polarity */
 		if (dev_read_bool(dev, "active-low"))
-			clrbits_32(regs + LED_SW_LED_IP_PPOL_REG, 1 << pin);
+			clrbits_32(regs + LED_PLED_OP_PPOL_REG, 1 << pin);
 		else
-			setbits_32(regs + LED_SW_LED_IP_PPOL_REG, 1 << pin);
+			setbits_32(regs + LED_PLED_OP_PPOL_REG, 1 << pin);
 	}
 
 	return 0;
-- 
2.39.5