From: Marek Vasut Date: Sat, 31 Aug 2024 20:31:47 +0000 (+0200) Subject: mtd: spi: renesas: Configure RPC PHY timing registers X-Git-Url: http://git.dujemihanovic.xyz/%22/img/sics.gif/%22/static/git-favicon.png?a=commitdiff_plain;h=d5162463243da66b27ac7ea96fcffb5da4c9a639;p=u-boot.git mtd: spi: renesas: Configure RPC PHY timing registers Make sure RPC PHY timing registers are configured before performing bus access. These registers might have been left unconfigured or may have been configured by a prior stage bootloader and leaving them unconfigured or misconfigured would interfere with U-Boot operation. Set PHYOFFSET1 DDRTMG field to 3 which enables DDR timing adjustment when SPIDRE or DRDRE = 0 and set PHYOFFSET2 OCTTMG field to 4 which makes the interface operate in Serial flash or HyperFlash mode. Signed-off-by: Marek Vasut --- diff --git a/drivers/spi/renesas_rpc_spi.c b/drivers/spi/renesas_rpc_spi.c index 5089098114..9aab71db1d 100644 --- a/drivers/spi/renesas_rpc_spi.c +++ b/drivers/spi/renesas_rpc_spi.c @@ -145,6 +145,12 @@ #define RPC_PHYCNT_WBUF BIT(2) #define RPC_PHYCNT_MEM(v) (((v) & 0x3) << 0) +#define RPCIF_PHYOFFSET1 0x0080 /* R/W */ +#define RPCIF_PHYOFFSET1_DDRTMG(v) (((v) & 0x3) << 28) + +#define RPCIF_PHYOFFSET2 0x0084 /* R/W */ +#define RPCIF_PHYOFFSET2_OCTTMG(v) (((v) & 0x7) << 8) + #define RPC_PHYINT 0x0088 /* R/W */ #define RPC_PHYINT_RSTEN BIT(18) #define RPC_PHYINT_WPEN BIT(17) @@ -227,6 +233,12 @@ static int rpc_spi_claim_bus(struct udevice *dev, bool manual) struct udevice *bus = dev->parent; struct rpc_spi_priv *priv = dev_get_priv(bus); + setbits_le32(priv->regs + RPCIF_PHYOFFSET1, + RPCIF_PHYOFFSET1_DDRTMG(3)); + clrsetbits_le32(priv->regs + RPCIF_PHYOFFSET2, + RPCIF_PHYOFFSET2_OCTTMG(7), + RPCIF_PHYOFFSET2_OCTTMG(4)); + /* NOTE: The 0x260 are undocumented bits, but they must be set. */ writel(RPC_PHYCNT_CAL | rpc_spi_get_strobe_delay() | 0x260, priv->regs + RPC_PHYCNT);