From: Pali Rohár Date: Tue, 20 Dec 2022 20:06:26 +0000 (+0100) Subject: doc: board: qemu-ppce500: Update supported and unsupported X-Git-Url: http://git.dujemihanovic.xyz/%22/img/sics.gif/%22/static/git-favicon.png?a=commitdiff_plain;h=a17be96b62476ccdb4838742f31e227963a69d65;p=u-boot.git doc: board: qemu-ppce500: Update supported and unsupported qemu can emulate also e500v1 core but cannot emulate CPUs from Freescale PowerPC QorIQ T and P series. Signed-off-by: Pali Rohár Signed-off-by: Heinrich Schuchardt --- diff --git a/doc/board/emulation/qemu-ppce500.rst b/doc/board/emulation/qemu-ppce500.rst index 5de0aaf55d..82b50a01de 100644 --- a/doc/board/emulation/qemu-ppce500.rst +++ b/doc/board/emulation/qemu-ppce500.rst @@ -7,7 +7,7 @@ QEMU PPC E500 QEMU for PPC supports a special 'ppce500' machine designed for emulation and virtualization purposes. This document describes how to run U-Boot under it. -The QEMU ppce500 machine models a generic PowerPC E500 virtual machine with +The QEMU ppce500 machine models a generic PowerPC e500 virtual machine with support for the VirtIO standard networking device connected to the built-in PCI host controller. Some common devices in the CCSBAR space are modeled, including MPIC, 16550A UART devices, GPIO, I2C and PCI host controller with @@ -39,6 +39,7 @@ embedded DTB created by QEMU reflects the new setting. Both qemu-system-ppc and qemu-system-ppc64 provide emulation for the following 32-bit PowerPC CPUs: +* e500v1 * e500v2 * e500mc @@ -61,8 +62,9 @@ When U-Boot boots, you will notice the following:: This is because we only specified a core name to QEMU and it does not have a meaningful SVR value which represents an actual SoC that integrates such core. You can specify a real world SoC device that QEMU has built-in support but all -these SoCs are e500v2 based MPC85xx series, hence you cannot test anything -built for P4080 (e500mc), P5020 (e5500) and T2080 (e6500). +these SoCs are e500v1/e500v2 based MPC85xx series, hence you cannot test anything +built for P10xx/P2010/P2020 (e500v2), P204x/P304x/P40xx (e500mc), P50xx/T10xx (e5500) +and T208x/T4080/T4160/T4240 (e6500). By default a VirtIO standard PCI networking device is connected as an ethernet interface at PCI address 0.1.0, but we can switch that to an e1000 NIC by::